Specifications2 min read

BRC Mesh in Kenya: A98 vs A142 vs A193, and Which One Your Slab Needs

The number in A142 tells you how much steel is in the mesh.

By Safeworld Steel Desk, SAFEWORLD STORES LTD

Drawing of welded BRC reinforcement mesh with 200 mm squares

BRC is the welded steel mesh laid in ground-floor slabs, driveways and paving. In Kenya it is mostly bought in rolls by its code: A98, A142, A193 and so on. Knowing what the code means makes the choice easy.

What the number means

The number is the steel area in square millimetres per metre width of mesh. The common A-meshes use square openings of 200 mm, and the wire size changes:

Mesh Wire Spacing Steel per metre Compared with A142
A66 about 4 mm 200 mm 66 mm² about 46%
A98 5 mm 200 mm 98 mm² about 70%
A142 6 mm 200 mm 142 mm² 100%
A193 7 mm 200 mm 193 mm² about 136%

You can check the maths: one 6 mm wire is 28.3 mm². At 200 mm spacing there are five wires per metre, so 5 × 28.3 ≈ 142.

Heavier codes such as A252 and A393 exist for industrial floors.

How BRC is sold in Kenya

Kenyan mills and stockists sell BRC mainly in 48 m rolls. Listings commonly give the roll as 2.1 m wide, which is about 100 m² per roll. Confirm the roll width with your supplier, because it decides how many rolls you need. Flat sheets are also made for jobs where a roll is awkward.

Which one does your slab need?

  • A142 is the everyday mesh for residential ground-floor slabs and driveways that carry cars. If there is no drawing and you are building a typical house floor, it is the mesh most engineers would be asked about first.
  • A66 is the lightest, with less than half the steel of A142. It is for paths, paving and light slabs that never take a car.
  • A98 has about 30% less steel. It is used for paving, paths and light slabs where the drawing specifies it.
  • A193 is for slabs that carry vehicle loads, such as yards, godown floors and driveways used by lorries.

If your structural drawing names a mesh, use that one. Downgrading A142 to A98 to save a little removes almost a third of the steel.

Laying it properly

Mesh only works if it is inside the concrete. A roll unrolled onto the ground and walked flat sits at the bottom of the slab, where it does almost nothing. Lift it onto spacers (concrete blocks or plastic chairs) so it sits at the depth the drawing shows. Overlap neighbouring sheets as the drawing specifies, typically at least one full 200 mm square, and tie the laps with binding wire.

Ordering

Measure the slab area, add an allowance for laps, and divide by the roll area. See BRC A142, A98 and A66.

Sources: Tononoka Steels catalogue, BRC codes and roll length; BRC A142 roll listings on Jiji Kenya.

Quick answers

What is the difference between A98 and A142 BRC?
A98 uses 5 mm wire and A142 uses 6 mm wire, both at 200 mm squares. A142 has about 45% more steel.
What BRC is used for a house floor slab in Kenya?
A142 is the usual choice for residential ground-floor slabs, unless the structural drawing specifies another mesh.
How long is a BRC roll?
Kenyan mills sell BRC mainly in 48 m rolls. Confirm the width with your supplier.

Know the sizes you need?

Send them on WhatsApp or through the quote form and we will reply with today's price and delivery from Syokimau.

Keep reading